 |
» |
|
|
|
A number of the commands have selection modifiers to restrict
their action to only those that meet certain criteria. The commands are immediately followed by one or more of the
following modifiers: - V
X.25 Virtual circuits - L
X.25 Link circuits - N
X.25 Link terminal configuration - X
X.25 Link statistics (not with the DC command) - O
Multiplexed terminals (using the ZCOM inbound and outbound
multiplexing) - M
Show ALL multiplexed terminals in a group - P
Show ALL terminals on a port - A
Show unavailable terminals as well (i.e. those configured
on an absent card)
These modifiers are specified as character additions to the
original command. The order that they are used is not important.
For example: TTL,nn,mm is used to display all the link circuits
in the range specified. The commands for which these modifiers are
available are: - TT
Terminal Status - DC
Terminal configuration
For example: - ttv,1,100
Will display all X.25 virtual circuits connected
to terminals in the range 1 to 100. - div,1,100
Will disable all X.25 virtual circuits connected
to terminals in the range 1 to 100. - dco,1,100
Will display the configuration for the multiplexed terminals
only (not the virtual circuits or links) in the range 1 to 100. - tdlv,1,100
Will display all X.25 links and virtual circuits
whose terminals are down. - ttm,50
Will display all terminals in the same multiplexed group
if ZLU 50 is a multiplexed terminal. - ttp,50
Will display all terminals on the same port as ZLU
50. - ttvp,50
Will display all X25 virtual circuits on the same
port as ZLU 50. - ttx,1,100
Will display all X25 link terminals with their statistical data,
in the given range. - tta,1,100
Will display all terminal ZLUs configured in the
range 1 to 100 including those on absent ACC cards.
The following commands can use the O, V, and L subset of the
modifiers. - EN,DI,AC,DE
Terminal control (enable etc.) - PT
Terminal status by port number
|
Printable version
