Summary of Commands

The commands available through ZMNTR, in alphabetic order, are as follows. Specific help for a particular command is obtained by entering "??" followed by the command for which help is required. For information on how the commands can be used for X.25, enter "?? X25".

      Command      Function 
 
          ??       Display help list of commands 
          !        Execute a shell command
          DC       Display configuration 
          EX       Exit program 
          FL       Flush read from terminals 
          LB       Perform loopback test on port
          LL       Set new list device 
          MX       Display mux configuration 
          PT       Display terminals on a port 
          RC       Reset RX TX and error counters 
          R        Repeat Enable/Disable 
          RE       Reissue read to terminals 
          SD       Shutdown terminals 
          SET      Set or display ZMNTR settings
          SU       Startup terminals 
          TM       Set time-out for auto-repeat display 
          TO       Skip to top of form 
          TR       Transfer to a command file 
          TT       Display terminal table 
          /E       Exit from ZMNTR

For the following commands, if no range of terminals is entered, then the last range entered for any of these commands is reused:

TT, DC, RC