WATCH Log Messages

watch 2 - Cannot open /opt/acc/cfg/zcomdevice file

Explanation:

The /opt/acc/cfg/zcomdevice is not on the system or the file has incorrect permissions.

Action:

If the file exists, make sure it has read permissions set for root, and that watch is being started by a superuser.

If the file does not exist, it must be either reinstalled, or recreated. It can be recreated by running zdgen, giving it the file /opt/acc/cfg/zcomdevice.txt as the input file and /opt/acc/cfg/zcomdevice as the output file.

watch 4 - Cannot find MONITOR device in /opt/acc/cfg/zcomdevice

Explanation:

There is no MONITOR entry in the /opt/acc/cfg/zcomdevice file.

Action:

Reinstall the /opt/acc/cfg/zcomdevice and /opt/acc/cfg/zcomdevice.txt files. If a custom .txt file is being used to create /opt/acc/cfg/zcomdevice, make sure it has an entry for MONITOR like the zcomdevice.txt file that is provided with the ACC base system product.

watch 5 - More than 1 MONITOR port (mux <num>, zlu=<num>)

Explanation:

More than one MONITOR entry was defined for a given Mux port in the .answ file corresponding to the .tmem file used to bring up the ZCOM Mux subsystem.

Action:

Fix the .answ file, rerun ttgen to create a new .tmem file, stop the ZCOM Mux subsystem, and restart it using the new .tmem file.

watch 6 - No MONITOR devices found in terminal table

Explanation:

There are no Term entries in the .answ file that correspond to the .tmem file that was used to bring up the ZCOM Mux subsystem. This means that the watch daemon may not be used.

Action:

Configure one MONITOR Term entry into the .answ file per Mux card.

watch 7 - Initialization complete <revision information>

Explanation:

This reports that watch has been started, and it reports the revision information for that program.

Action:

No action required.

watch 8 - time interval is <number> seconds

Explanation:

This is just reporting the timeout value that was used when watch was started.

Action:

No action required.

watch 12 - Exit program

Explanation:

The watch program terminated.

Action:

If the program terminated unexpectedly, investigate the reason and correct the situation as appropriate.

watch 421 - watch semaphore failed: <error>

Explanation:

The watch program failed to obtain its semaphore from the system.

Action:

This could be a internal error or a system related error. Report this problem with the printed error to your HP support representative.

watch 422 - watch daemon is already active, terminating this copy.

Explanation:

The watch daemon was already running when it was started again. The second instance of watch terminated.

Action:

No action required.